Mitox 260B - Page 14

260B Blower / 280BV Blower Vacuum
14
Original Instructions Version July 12
IMPORTANT !
A two-position “ON-OFF” switch located on the left of the machine handle grip controls the engine ignition.
Cold Engine Starting Procedure
1.2.
3. SettheignitionswitchtotheONposition.
4. Slowlypulltherecoilstarterhandleuntilengagementofthepawlswiththeywheelisfelt.
5. Whileholdingtheunit,pulloutthestarterropermlyuntilengineres(indicatedbya‘cough’
 fromtheengine).
6. Pushthechokerodbackin(chokeisopen).
7. Pull the starter rope until the engine starts.
8. Allow the engine to warm up before use.
Prime the fuel system by repeatedly
depressing the fuel primer bulb
until no air bubbles are visible in
the fuel discharge line.
ColdEngineOnly.Chokethe
engine by pulling the choke
control to the fully extended
position(chokeisclosed).