Mitox 260B - Page 20

260B Blower / 280BV Blower Vacuum
20
Original Instructions Version July 12
Every 10/15 Hours Use
     1.Usethesparkplugwrenchtoremovethespark
     plug(turncounter-clockwisetoremove).
2. Clean and adjust the spark plug gap to
0.6~0.7mm. Replace any damaged or visibly worn
     plugwithachampionRCJ6Yorequivalent.
     3.Installthesparkplugnger-tightinthecylinder
head, and then tighten it rmly with the spark plug
     wrench.Ifatorquewrenchisavailable,torquethe
     sparkplugto148-165inchpounds.
Every 50 Hours Use (MOREFREQUENTLYIFYOUNOTEREDUCEDPERFORMANCE)
     INSPECTIONInspecttheentiremachineand
tubes for damage, including loose or missing
components, and repair as necessary.
SPARK PLUG Replace the spark plug with a
     championL9T(LD),gappedto(0.6~0.7)mm.
     FUELFILTERUseawirehooktoextractthefuellter
from inside the fuel tank, and then remove and
wash the lter element in clean fuel.
Before reinstalling the lter, inspect the condition
of the fuel line. If damage or deterioration is noted,
the vacuum should be removed from service until
it can be inspected by a trained service technician.
COOLINGSYSTEMRemovetheenginecover(asdescribedunder“SparkArrestor”),anduseawoodorplastic
scraper and a soft brush to remove dirt and debris from the cylinder ns and crankcase.