CORRECT USE OF THE 3 TOOTH
BLADE.
All safety systems and parts
of the machine must be in good order
when the brushcutter is in use.
When using the 3 tooth blade, avoid
the risk of serious injury by adopting
good safety practices. Pay attention to
the drawing below.
When cutting woody and fibrous
materials always use the 3 tooth blade in
the circular direction “A” below.
The circular position “B” is
acceptable only if the brushcutter is
gripped very tightly. It is not
recommended.
The circular position “NO” is
forbidden as it can endanger people,
animals and other objects. Never use
this position.
NO!
A
B
All safety devices and
safety equipment must be maintained in
good operational condition at all times.
The engine and cutting head must be at
a complete standstill during assembly,
repair and cleaning operations.
Put the ignition switch to the “STOP”
position.
Brushcutters vibrate during use. Although
equipped with an anti-vibration device, the
vibrations can generate increased fatigue.
For this reason it is recommended that
regular pauses be taken during work.
It is also recommended that, after a few
hours of work, the machine be allowed to
idle at low rpm’s for a few minutes to
allow the engine to cool.
MAINTENANCE
Carburettor
- Idle speed adjustment.
- Screw or unscrew the butterfly screw
until the engine is at around 2500 Rpm.
- This adjustment requires the use of a
small Philips screwdriver.
Annual Engine Maintenance
- Clean air filter in warm soapy water,
dry and lightly oil before assembly, or
replace as necessary.
- Remove and replace petrol filter.
- Remove and inspect spark plug.
- Replace if worn, or if it has excessive
build-up of carbon.
To Next Page
Loading...
