GEAR BOX.
Every 25 hours, grease the gearbox.
Unscrew the lateral cap of the gearbox and
put grease inside using an appropriate tool.
Use special gearbox grease that is designed
for high temperature conditions.
Screw the cap back on tightly.
MAINTENANCE AND STORAGE
AFTER USE.
After use, clean the brushcutter thoroughly.
Remove all residual grass and dirt; making
sure no debris is wrapped round the cutting
head. If possible re-wrap the machine in its
original packing material for safe storage
or transportation.
Avoid hitting or cutting the fuel tank while
putting the machine to the ground. Do not
let the brushcutter fall as this may cause
damage.
Whenever the machine is out of use for
over 1 month, take the following steps:
- Completely empty the fuel tank.
- Protect all metal parts from corrosion by
applying a thin coat of oil.
- With the ignition switch in the stop
position remove the spark-plug, put some
drops of oil in the cylinder, then pull the
recoil starter 2 to 3 times in order to
distribute evenly the oil. Replace the spark
plug.
- During the storage period, it is
recommended that the engine be run for a
few minutes every 3 months.
- In order to re-mix the oil with the
petrol, vigorously shake the mixture
in the fuel tank before use.
- Dispose of fuel mixture after one
month.
TROUBLESHOOTING
Power loss or engine stopping.
- Check that the fuel tank is not empty.
- The mixture does not reach to the
carburettor. Clean or change the fuel
filter in the fuel tank.
- There is water in the mixture. Drain
then clean the entire fuel system .
- The air filter is dirty. Clean the air filter.
Wash the foam with water and soap.
Dry the foam, oil it, and replace it in
the filter.
- There are carbon deposits in the
cylinder exhaust pipe or the muffler.
Clean or change the muffler.
-
Bad quality cut.
- Area too overgrown or thick for the
available engine power. Take smaller
quantities with each pass of the cutting
head.
- Wrapped debris on the cutting. Stop the
machine and clear the obstruction as
previously instructed.
- If blade is used: blade worn or not
sharp enough. Change the blade.
WARNING.
Using the engine with a petrol/oil mixture that does not conform to the
the manufacturer’s specification will invalidate the warranty.
Only use the machine with the cutting tools provided by the manufacturer.
Nylon head : CG305F.8
3 teeth blade : CG420-2
The use of the brush-cutter with a "saw blade" is strictly forbidden
To Next Page
Loading...
