Mitox 6000HTDX - Maintenance Schedule; Specification

15
MAINTENANCE SCHEDULE
SPECIFICATION
Model
6000HTDX..................................................................... …......................Double-action type
7000HTSX........................... ... ... ....... ............................................................. Single blade
Blade length (from the tip of Gear Case)
7000HTSX / 6000HTDX.............................. .... .............................................. 750 / 610 mm
effective cutting length
7000HTSX / 6000HTDX.................................................................................. 660 / 550 mm
Engine
Model .......................................... .... .... .... .... ...................................................... 1E34F-2
Displacement .......................................................................................................... 24.5 cm
3
Carburetor ............................................................ ...................................... Diaphragm type
Ignition system ................................................................... I.C.controlled flywheel magneto
Spark plug ........................................................................................................ NGK BPR7A
Fuel .............................................................................................. mixture (Petrol 32 : Oil 1)
(using JASO FC or ISO EGC grade oil)
Fuel tank capacity ...................................................................................................... 0.33 L
Starter ............................................................................................................. Recoil starter
Clutch .......................................................................................................... Centrifugal type
Dry weight
7000HTSX / 6000HTDX ......................................................................................5.3 / 5.4 kg
Specifications are subject to change without notice.
Component Procedure Before
use
Every
15
Hours
use
Every
25
Hours
use
Every
50
Hours
use
note
Fuel leaks / spillage Wipe up
X
Fuel tank, filter Inspect / clean
X
Replace if necessary
Idle adjust screw See above
X
Adjust carburettor if
necessary
Spark plug BPMR7A Clean and readjust
plug gap
X
GAP .025” (0.6-0.7mm)
Replace, if necessary
Cylinder fins, Intake air
cooling vent
Clean
X
Muffler, Spark arrestor,
cylinder exhaust port
Clean
X
Throttle lever, ignition
switch
Check operation
X
Air filter Clean
X
Screws, nuts, bolts Tighten / replace
X
Not adjustment screws
Check that the vibration
elements are not damaged
Check operation
X
Replace if necessary
Check all nuts and bolts Check
X
Clean and oil the blades Clean and oil
X
Check blades for damage
X
Replace if necessary