Mitox CS38 - Service Schedule; Troubleshooting: Power Loss or Engine Stopping

CS38 / CS41 SELECT Chainsaw
26
Original Instructions Version July 16
CS38-41_130716
Service Schedule
Troubleshooting: Power loss or engine stopping.
• Check that the fuel tank is not empty
• The mixture does not reach the carburettor. Change the fuel filter in the fuel tank
• There is water in the mixture. Drain then clean the fuel system
• The air filter is dirty. Clean the air filter
• There are carbon deposits in the cylinder exhaust pipe or muer. Clean or change muer
• Spark plug is worn. Replace spark plug
Component Procedure
Before
Use
Every
25
Hours
Every
50
Hours
Every
100
Hours
Note
Fuel Leaks / Fuel
Spillage
Wipe Away
•
Fuel Tank / Fuel
Filter
Inspect / Clean
• •
Replace if
Neccessary
Idle Adjusting
Screw
See Adjusting
Carburettor
•
Adjust if
Neccessary
Spark Plug Clean and
Readjust Plug Gap •
Gap 0.025in (0.6-
0.7mm) Replace if
Neccessary
Cylinder Fins /
Intake Air Cooling
Vent
Clean
•
Muer / Spark
Arrestor / Cylinder
Exhaust Port
Clean
•
Throttle Lever /
Ignition Switch
Check Operation
•
Air Filter Clean •
Screws / Nuts /
Bolts
Tighten / Replace
• •
Except Adjusting
Screws
Oiling Port Clean •
Guide Bar Clean •
Sprocket Inspect / Replace •
Saw Chain Inspect / Sharpen •