Periodical Service Points
Cylinder Fins
Dust clogging between the cylinder ns will cause
overheating of the engine.
Periodically check and clean the cylinder ns after removing
the cylinder cover.
When installing the cylinder cover, make sure that switch
wires and grommets are tted correctly.
Fuel lter
Using a wire hook, take out the lter (1) from the ller port.
Disassemble the lter and clean with petrol, or replace with
a new one if needed.
Spark plug
Clean the electrodes with a wire brush and reset the gap to
0.65 mm as necessary.
Plug type: NGK: BPRM7A
Sprocket
Check for cracks and for excessive wear interfering with the
chain drive. If the wear is considerable, replace it with a new
a one. Never t a new chain on a worn sprocket, or a worn
chain on a new sprocket.
To Next Page
Loading...
