To Next PageTo Next PageWhat to do if Mitsubishi Electric 700 shows overcurrent trip during constant speed?
If your Mitsubishi Electric Inverter is tripping due to overcurrent during constant speed, try the following: * Ensure the load remains stable. * Inspect the wiring to rule out output short circuits or ground faults. * Reduce the setting of the stall prevention operation level. * Activate the fast-response current limit operation.
General| Output Frequency | 400 Hz |
|---|---|
| Power Range | 0.4 to 15kW |
| Overload Capacity | 150% for 60 seconds |
| Control Method | V/f Control, Sensorless Vector Control |
| Braking Unit | Built-in |
| Communication | RS-485, Modbus RTU |
| Protection Features | Overcurrent, Overvoltage, Undervoltage, Overheating, Short Circuit, Ground Fault |
| Protection Functions | Motor Overload |
| Ambient Temperature | -10°C to +50°C (14°F to 122°F) |
| Storage Temperature | -20°C to +65°C (-4°F to +149°F) |
| Cooling Method | Forced air cooling |
| Enclosure | Open type (IP20) |
| Enclosure Rating | IP20 |
| Rated Horsepower Range | 0.5 |
