What to do if Mitsubishi Electric 700 shows overcurrent trip during constant speed?
If your Mitsubishi Electric Inverter is tripping due to overcurrent during constant speed, try the following: * Ensure the load remains stable. * Inspect the wiring to rule out output short circuits or ground faults. * Reduce the setting of the stall prevention operation level. * Activate the fast-response current limit operation.
General| Output Frequency | 400 Hz |
|---|---|
| Power Range | 0.4 to 15kW |
| Overload Capacity | 150% for 60 seconds |
| Control Method | V/f Control, Sensorless Vector Control |
| Braking Unit | Built-in |
| Communication | RS-485, Modbus RTU |
| Protection Features | Overcurrent, Overvoltage, Undervoltage, Overheating, Short Circuit, Ground Fault |
| Protection Functions | Motor Overload |
| Ambient Temperature | -10°C to +50°C (14°F to 122°F) |
| Storage Temperature | -20°C to +65°C (-4°F to +149°F) |
| Cooling Method | Forced air cooling |
| Enclosure | Open type (IP20) |
| Enclosure Rating | IP20 |
| Rated Horsepower Range | 0.5 |
To Next Page
