Do you have a question about the Mitsubishi Electric City Multi PUHY-P200YNW-A and is the answer not in the manual?
Model | PUHY-P200YNW-A |
---|---|
Series | City Multi |
Refrigerant | R410A |
Operating Temperature (Cooling) | -5 to 46°C |
Power Supply | 380-415V, 50Hz |
Operating Temperature (Heating) | -20 to 15°C |
General safety guidelines for operating the air conditioner unit.
Safety measures for transporting and installing the outdoor unit.
Safety guidelines for refrigerant piping and electrical wiring installation.
Further safety advice for relocation, repair, and general operation.
Basic information about the air-conditioning equipment.
Overview of compatible outdoor unit combinations.
Technical specifications for P series outdoor units.
Technical specifications for EP series outdoor units.
List of package contents for P series outdoor units.
List of package contents for EP series outdoor units.
Guidelines for selecting the installation location for a single outdoor unit.
Guidelines for selecting the installation location for multiple outdoor units.
Important restrictions and rules for refrigerant piping installation.
Guidelines for selecting the correct refrigerant pipes and their specifications.
How to select the appropriate twinning kit for unit combinations.
Examples of how to connect refrigerant pipes between units.
Steps to remove pinched connecting pipes before installation.
Methods for connecting refrigerant pipes to indoor and outdoor units.
Procedure for testing the refrigerant piping system for leaks.
Guidelines for insulating refrigerant pipes to prevent condensation.
Procedures for evacuating the refrigerant system using a vacuum pump.
Guidelines for adding refrigerant and calculating the correct amount.
Formula and method for calculating additional refrigerant based on piping length.
Steps for charging the system with the calculated amount of refrigerant.
Precautions and preparation steps before starting electrical work.
Guidelines for selecting power cables and ensuring adequate device capacity.
Specifications for control cables used in the system.
Information on unit codes and the maximum number of connectable units.
Detailed instructions for wiring connections inside the control box.
How to route power cables through knockout holes in the control box.
Methods for securing and routing cables within the unit.
Procedures for connecting various cables to terminal blocks.
How to set addresses for indoor and outdoor units and controllers.
Preparatory steps and checks before performing the system test run.
How to configure various unit functions using dipswitches.
How refrigerant charge affects unit operation characteristics.
Checking for normal operation symptoms and identifying potential issues.
Rating plate details for P series outdoor units.
Rating plate details for EP series outdoor units.