How to fix Mitsubishi Electric FRESH MASTER GUF-50RD4 Air Conditioner when it does not humidify?
If your Mitsubishi Electric Air Conditioner (GUF-50, 100RDH4 only) does not humidify, ensure that the Fresh Master is set to the “heating” mode. Also, check that water is being supplied by opening the service valve.
Why is no cool or warm air coming from my Mitsubishi Electric FRESH MASTER GUF-50RD4?
If cool or warm air isn't coming out of your Mitsubishi Electric Air Conditioner, it might be because the restart-preventing circuit is active for 3 minutes to protect the compressor. Wait for a while, as it can take up to 3 minutes for the compressor to start. Also, if the Fresh Master operation started during heating or defrosting, wait until the defrosting operation ends before heating begins.
What to do if my Mitsubishi Electric Fan does not run?
If your Mitsubishi Electric Fan isn't running, check the following: * Ensure there isn't a power failure. If there was, press the ON/OFF button after power is restored. * Verify that the power supply is turned ON. If it's OFF, turn it ON. * Inspect the fuse in the power supply. If it's blown, replace it. * Check the earth leakage isolator. If it's tripped, reset it.
Why does my Mitsubishi Electric Fan run briefly, but soon stops?
Your Mitsubishi Electric Fan might be stopping soon after starting due to: * Obstacles blocking the air inlet and outlet of the unit. Remove any obstructions and restart. * Filters clogged with dust and dirt. Clean the filters and then rerun the fan.
What to do if cool or warm air does not come out of my Mitsubishi Electric Fan?
If cool or warm air isn't coming out of your Mitsubishi Electric Fan, it might be due to: * The restart-preventing circuit being in operation, which can last up to 3 minutes to protect the compressor. Wait for a while. * Starting the Fresh Master operation during heating or defrosting. Wait for the unit to complete these cycles.
What to do if Mitsubishi Electric Fresh Master Air Conditioner runs briefly but soon stops?
If your Mitsubishi Electric Fresh Master runs briefly but soon stops, it might be due to obstacles blocking the air inlet or outlet of the Fresh Master and outdoor unit. Remove any obstructions and rerun the system. Alternatively, the filters could be filled with dust and dirt. Clean the filters and then rerun the system.
What to do if my Mitsubishi Electric Air Conditioner shows a drain error?
If your Mitsubishi Electric Air Conditioner displays a drain error, it indicates that the drain water is not being discharged properly. Ensure the unit is levelly installed and that the drain pipe has a gradient of more than 1/100. Also, fix any water leaks.
What to do if my Mitsubishi Electric FRESH MASTER GUF-50RD4 is booting system?
If your Mitsubishi Electric Air Conditioner is stuck on booting, conduct group registration. If there is a master system controller such as the central controller, use the controller to conduct group registration.
What to do if my Mitsubishi Electric FRESH MASTER GUF-50RD4 Air Conditioner operation display turns off immediately?
If the operation display on your Mitsubishi Electric Air Conditioner remote turns off immediately after appearing, ensure that the main power is supplied to the Fresh Master.
What to do if my Mitsubishi Electric Air Conditioner has an indoor temperature sensor error?
If your Mitsubishi Electric Air Conditioner is showing an indoor temperature sensor error, firmly connect each connector.
General| Brand | Mitsubishi Electric |
|---|---|
| Model | FRESH MASTER GUF-50RD4 |
| Category | Air Conditioner |
| Language | English |
To Next Page
