What to do if excessive speed command is detected on Mitsubishi Electric MELFA CR750?
If an excessive speed command is detected by the speed monitoring function, check the robot movement or the monitoring speed setting. Or else, check that the reaction time (parameter SFREACT) setting is not too short.
What to do if robot motion command and feedback are inconsistent on Mitsubishi Electric MELFA CR750?
If the robot motion command and the feedback are inconsistent, check the details of the robot movement, the terminal load setting, or interference with the peripheral equipment.
What to do if the duplex magnetic contactor status signal status is not consistent on my Mitsubishi Electric Controller?
If the duplex magnetic contactor status signal status is not consistent, turn the power OFF, then ON again to reset the error. If the same error recurs, contact the manufacturer.
What to do if the duplex safety relay status signal status is not consistent on my Mitsubishi Electric Controller?
If the duplex safety relay status signal status is not consistent, turn the power OFF, then ON again to reset the error. If the same error recurs, contact the manufacturer.
What to do if the power supply output voltage is out of the specified range on my Mitsubishi Electric MELFA CR750 Controller?
If the power supply output voltage is out of the specified range, turn the power OFF, then ON again to reset the error. If the same error recurs, contact the manufacturer.
General| Brand | Mitsubishi Electric |
|---|---|
| Model | MELFA CR750 Series |
| Category | Controller |
| Language | English |
To Next Page
