26
4 PROCEDURES BEFORE OPERATION
4.3 Creating a Project
• When mounting or removing the SD memory card while the power is ON, follow the above-mentioned procedure.
Otherwise, the data in the card may become corrupted.
• When removing an SD memory card which is being accessed by a function, the CARD LED is turned OFF after the access
is completed. When the CARD LED is turned OFF depends on the accessing function.
• When SM605 (memory card interchange protect flag) is ON, the CARD LED is not turned OFF even if the SD memory card
stop switch is pressed. If the CARD LED is not turned OFF, turn ON SM606 (memory card disable request) so that the SD
memory card cannot be used.
4.3 Creating a Project
Activate the engineering tool and create a project.
[Project] [New]
Procedure
Create a program, following the procedure below. This procedure is for programs described in ladder diagram.
Module label is a label where the I/O signals and buffer memory areas of a module have already been
defined. Use of module labels allows programming without being aware of module internal addresses.
1. Select the model of the CPU module used. Then, specify a
programming language used for the project. Select "Ladder",
and click the [OK] button.
2. Click the [Yes] button when the window for adding module
labels of the CPU module appears.
To Next Page
Loading...
