4 PROCEDURES BEFORE OPERATION
4.4 Connecting a Personal Computer
27
4
4.4 Connecting a Personal Computer
Connect the CPU module to a personal computer that has an engineering tool installed.
For details on the system configuration examples and GX Works3 settings, refer to the following manual.
MELSEC iQ-F FX5U User's Manual (Hardware)
MELSEC iQ-F FX5UC User's Manual (Hardware)
When Ethernet cable is used (direct connection)
Connect a personal computer directly to the CPU module, following the procedure below.
For the FX5 CPU module, the Ethernet adapter on the personal computer side used for the Ethernet port
direct connection can be specified.
Select the adapter on the "CPU Module Direct Coupled Setting" window.
1. Connect a personal computer to the CPU module using the
Ethernet cable.
2. Select [Online] [Current Connection Destination] on the
menubar of the engineering tool.
3. Click the [CPU Module Direct Coupled Setting] button (1) on the
"Specify Connection Destination Connection" window.
4. Select [Ethernet] for the connection method for the CPU
module and click the [Yes] button.
5. Click the [Connection Test] button (2), and check if the personal
computer is connected to the CPU module.
To Next Page
Loading...
