4 PROCEDURES BEFORE OPERATION
4.4 Connecting a Personal Computer
29
4
Engineering tool settings
From the engineer tool, this is done on the “Specify Connection Destination Connection” window.
Select “Online” [Current Connection Destination] .
Connection of the Ethernet cable
Use the [Find] button in the "PLC side I/F Detailed Setting of PLC Module". The IP address of the connected
CPU module can be searched and can be set to “IP Address”.
1. Select "Ethernet Board" for "PC side I/F"(1).
2. Select "PLC Module" for "PLC side I/F"(2).
Input the CPU IP address or host name in the “PLC side I/F Detailed
Setting of PLC Module” screen as shown in the left figure.
In case of host name, set the name specified in the Microsoft
Windows
hosts file.
3. Double-click "No Specification" (3) on the "Specify Connection
Destination Connection" window to set "Other Station Setting".
Select an item appropriate to the operating environment.
1. Connect a personal computer to the CPU module via a hub.
(1)(1)(1)
(2)(2)(2)
(3)(3)(3)
To Next Page
Loading...
