Mitsubishi Electric MELSEC iQ-R08CPU - Chapter 2 Parameter Settings; Setting Parameters; Basic Settings

2 PARAMETER SETTINGS
2.1 Setting Parameters
241
2
2 PARAMETER SETTINGS
This chapter describes the parameter settings required for communications between the Ethernet-equipped module and
external devices.
2.1 Setting Parameters
1. Add the RJ71EN71 in the engineering tool.
* 1
[Navigation window]  [Parameter]  [Module Information]  Right-click  [Add New Module]
2. The basic setting and application setting are included in the parameter settings. Select one of the settings from the tree
on the window shown below.
[Navigation window]  [Parameter]  Tar ge t mo du l e  [Module Parameter]
3. After setting parameters, click the [Apply] button.
4. Write the settings to the CPU module using the engineering tool.
[Online]  [Write to PLC]
5. The settings are reflected by resetting the CPU module or powering off and on the system.
*1 Addition of the module is not required when using the Ethernet function of the CPU module (built-in Ethernet port part).
2.2 Basic Settings
Set the own node settings, CC-Link IEF Basic Setting
*1
, and external device configuration of the Ethernet-equipped module.
*1 This setting is displayed only for modules supporting CC-Link IE Field Network Basic.
Setting items Description Reference
Own Node Settings Set the IP address and communication data code of the Ethernet-equipped module. Page 242 Own Node Settings
CC-Link IEF Basic Setting
*1
Set the network configuration settings and refresh settings of CC-Link IE Field
Network Basic.
CC-Link IE Field Network Basic
Reference Manual
External Device Configuration Set the method and protocol used for communicating with external devices. Page 244 External Device
Configuration