5 - 61
MELSEC-Q
5 DATA USED FOR POSITIONING CONTROL
Setting Value, setting range
Value set with peripheral device
Setting value buffer memory
address
Servo amplifier setting invalid ( : Invalid, : Valid)
MR-
H-BN
MR-
H-BN4
MR-
J2-B
MR-
J2S-B
MR-
J2-Jr
MR-
J2M-B
Value set with PLC program
Default
value
Axis 1 Axis 2 Axis 3 Axis 4
Motor type selection
00
H
1: is used to set up the setting
value.
(Hexadecimal)
80
H
30103 30203 30303 30403
0000 to FFFF 0000
H
30104 30204 30304 30404
1 to 3 1 30105 30205 30305 30405
0
Feedback pulse
number
1: is used to set up the setting
value.
(Hexadecimal)
0255 30106 30206 30306 30406
0 to 1 0 30107 30207 30307 30407
2: Set the parameter value and switch power off once (The parameter is transferred to servo amplifier from QD75), then switch it on
again to make that parameter setting valid.
To Next Page
Loading...