2 - 4
MELSEC-Q
2 SYSTEM CONFIGURATION
2.2 Component list
The positioning system using the QD75 is configured of the following devices.
No. Part name Type Remarks
1 Positioning module
QD75M1
QD75M2
QD75M4
QD75M
Number of control axes
M: SSCNET model
2
GX Configurator-
QP
SW
D5C-QD75P-
E
Refer to GX Configurator-QP Operating Manual for details.
3 Personal computer
DOS/V personal
computer
(Prepared by user)
Refer to GX Configurator-QP Operating Manual for details.
4 RS-232 cable QC30R2
(Prepared by user)
An RS-232 cable is needed for connecting the CPU module with a
personal computer (DOS/V).
For details, refer to GX Configurator-QP Operating Manual.
5 USB cable –
(Prepared by user)
A USB cable is needed for connecting the CPU module with a personal
computer (DOS/V).
For details, refer to GX Configurator-QP Operating Manual.
6 Servo amplifier – (Prepared by user)
7
Manual pulse
generator
–
(Prepared by user)
Recommended: MR-HDP01 (Mitsubishi Electric)
8
SSCNET cable
1
(For connecting
between the QD75
and the servo
amplifier)
–
(Prepared by user)
Cables are needed to connect the QD75 with the servo amplifier.
9
Cable
1
(For connecting
between the QD75
and the external
device)
–
(Prepared by user)
Cables are needed to connect the QD75 with the external device.
(Prepare them referring to the manuals for the connected devices and
information given in 3.4.2 of this manual.)
1: The SSCNET cable connecting the QD75 and servo amplifier, external device connection connector has been
prepared. Refer to the below table.
To Next Page
Loading...