Mitsubishi Electric MELSEC-Q QD75M - Page 252

5 - 161
MELSEC-Q
5 DATA USED FOR POSITIONING CONTROL
Storage buffer
memory address
Setting value
Default
value
Axis 1 Axis 2 Axis 3 Axis 4
Set with a decimal.
Setting
value
Servo OFF command
0: Servo ON
1: Servo OFF
K
When all axis servo ON is valid.
0 1551 1651 1751 1851
Set with a decimal.
Setting
value
K
Torque output setting
0 to 500
0 1552 1652 1752 1852
Set with a decimal.
Setting
value
Servo amplifier read request
0: Servo amplifier read complete
1: Servo amplifier read request
K
0 1553 1653 1753 1853