9 - 96
MELSEC-Q
9 MAJOR POSITIONING CONTROL
Speed-position switching signal setting
The following table shows the items that must be set to use the external command
signals (CHG) as speed-position switching signals.
Buffer memory address
Setting item
Setting
value
Setting details
Axis 1 Axis 2 Axis 3 Axis 4
Pr.42
External
command
function
selection
2
Set the "2: speed-position and
position-speed switching
requests".
62 212 362 512
Cd.8
External
command
valid
1
Set "1: Validate external
command".
1505 1605 1705 1805
Refer to Sections 5.2 "List of parameters" and Section 5.7 "List of control data" for information on the
setting details.
To Next Page
Loading...