12 - 28
MELSEC-Q
12 CONTROL SUB FUNCTIONS
The following table shows the "
Md.35
Torque limit stored value" of the
buffer memory address.
Buffer memory address
Monitor item
Monitor
value
Storage details
Axis
1
Axis
2
Axis
3
Axis
4
Md.35
Torque limit stored
value
The "torque limit value" valid at that time is
stored. (
Pr.17
,
Pr.54
,
Cd.22
, or
Cd.101
)
826 926 1026 1126
Refer to Section 5.6 "List of monitor data" for information on the setting details.
REMARK
•
Parameters are set for each axis.
•
It is recommended that the parameters be set whenever possible with GX
Configurator-QP. Execution by PLC program uses many PLC programs and
devices. The execution becomes complicated, and the scan times will increase.
To Next Page
Loading...