To Next PageTo Next PageWhy does my Mitsubishi Electric Mr. SLIM PLA-SM EA Air Conditioner have an unpleasant odor?
Your Mitsubishi Electric Air Conditioner might be emitting an unpleasant odor because the indoor unit draws in air containing gases from walls, carpeting, furniture, and trapped odors in clothing, and then blows this air back into the room.
Why is water or vapor emitted from my Mitsubishi Electric Air Conditioner outdoor unit?
During cooling mode, water may form and drip from the cool pipes and joints of your Mitsubishi Electric Air Conditioner. During heating mode, water may form and drip from the heat exchanger. Also, during defrosting mode, water on the heat exchanger evaporates, and water vapor may be emitted.
Why do the vanes on my Mitsubishi Electric Air Conditioner move past the set position?
When the airflow direction is changed on your Mitsubishi Electric Air Conditioner, the vanes move to the set position after detecting the base position.
What does “PLEASE WAIT” mean on my Mitsubishi Electric Mr. SLIM PLA-SM EA remote controller display?
The “PLEASE WAIT” message on your Mitsubishi Electric Air Conditioner remote controller display indicates that the initial settings are being performed. Wait approximately 3 minutes.
General| Refrigerant | R410A |
|---|---|
| Series | PLA-SM EA Series |
| Heating Capacity | 2.5 kW to 8.0 kW |
| Energy Efficiency Ratio (EER) | 3.50 to 4.50 |
| Energy Efficiency Ratio (Cooling) | 3.50 to 4.50 |
Explains warning symbols for fire risk and general operational advice.
Covers safe handling, storage, and disposal guidelines for the unit.
Details parts of the indoor unit including fan, vane, louver, and filter.
Introduces the wired remote controller and its main interface elements.
Describes the function of primary buttons and the LCD on the remote controller.
Explains the "Full" and "Basic" display modes of the remote controller.
Details various icons and indicators shown on the remote controller display.
Identifies and explains the function of each button on the remote controller.
Explains operational mode, temperature setting, fan speed, and vane setting icons.
Describes the 3D i-see sensor for air distribution control.
Provides tips for using the wireless remote controller, including pointing direction and signal reception.
Step-by-step guide for installing and replacing batteries in the remote controller.
Shows the external connections of the outdoor unit, including power and piping.
Instructions for switching the unit on/off and how status is remembered.
How to select operating modes and adjust the preset temperature.
Details how the unit automatically switches between cooling and heating.
Instructions for selecting fan speeds and notes on actual fan speed variations.
How to adjust airflow direction, including vane and vent settings.
Detailed steps for setting vane angles and ventilation modes.
How to fix the air direction of specific outlets on the unit.
Procedure for setting manual vane angles using wired or wireless controllers.
How to set up weekly operating schedules and transmit settings.
How to operate the unit in emergency modes when the remote controller is unavailable.
How to check filter status, clean, or replace filters and reset the indicator.
Detailed steps and precautions for cleaning the air filters.
Lists common problems like poor performance, noises, and provides troubleshooting steps.
Addresses issues like delayed start-up, unexpected operation, and timer errors.
Covers problems with the remote controller display, signal, and room noise levels.
Provides technical specifications for different PLA-SM models.
