(4)
The initial set temperature is decided by the initial room temperature for the first 2 min. after the system starts.
tG
UI
JTROL"
/
Less than 76°F
Initial room temperature
minus 2 deg("F)
Initial set temperature
Model
%
1
After the system restarts by the remote controller, the system operates with the previous set temperature regardless
of the initial set temperature.
Initial room temperature
(5)
1
FEEL CONTROL buttons
In
'I
FEEL CONTROL" mode, set temperature is decided by the microprocessor based on the room temperature. In
addition, set temperature is controlled by
I
FEEL buttons when you feel too cool or too warm, and when you feel
comfortable the button fixes the comfortable temperature.
When the
I
FEEL button is pressed,
I
FEEL MONITOR lamp on the indoor unit flickers for a second with beeps.
*Variable control
When the
TOO COOL
or
TOO
WARM
-
button is pressed, the set temperature is changed based on the room temperature. As the
set temperature range is variable, this is called "Variable control". The variable control operates only in
'I
FEEL
CONTROL" mode.
In DRY mode of
'I
FEEL CONTROL". the set temperature range is fixed
+
2
deg ("F).
:=!.-.To raise the set temperature by
2
deg.
--
3
deg.('F)
OKAY
--.To fix and memorize the comfortable present temperature
0
WARM--^^
lower the set temperature
2
deg.
--
3
deg. ('F)
0
-
I
FEEL
MONITOR
lamp
on the indoor unit
-
When
I
FEEL CONTROL button is pressed,
I
FEEL MONITOR lamp on the indoor unit flickers with beeps and shows the
temperature control condition.
I
FEEL MONITOR lamp
\,
\I
\I
b-b
Shows difference between set temperature and room temperature is more than
3
deg. ("F)
t\
I,
I
\
During this condition, I FEEL button is not available.
Wait for about 15 min.
D
Shows difference between set temperature and room temperature is 2 deg.
-3
deg. (OF)
\I
The buttons are available.
DD*
Shows room temperature has almost reached set temperature. The difference is less than 2°F.
The buttons are available.
NOTE
During
"I
FEEL CONTROL" operation, thermostat (SET TEMP.) is not available. Use
"I
FEEL CONVKN-"
buttons to set temperature
Once the set temperature is set, the microprocessor memorizes the temperature and the system restarts at
the same set temperature.
*The set temperature range is 61 to 88F in COOL
DRY mode of
'I
FEEL CONTROL".
When the main power is turned off, the settings are canceled. Initial set temperature will be decided as
shown in the above table.
To Next Page
Loading...
Need help?
General
