To Next PageTo Next Page
Need help?Do you have a question about the Mitsubishi Electric MSZ-GL18NA-U2 and is the answer not in the manual?
General| Cooling Capacity | 18, 000 BTU/h |
|---|---|
| Heating Capacity | 20, 000 BTU/h |
| Voltage | 208/230 V |
| Operating Temperature (Cooling) | 14°F to 115°F |
| Refrigerant | R410A |
| Power Supply | 60 Hz |
Explains warning and caution symbols indicating potential hazards.
Defines the meaning of symbols used throughout the manual for safe operation.
Step-by-step guide for inserting batteries into the remote controller correctly.
Instructions on how to set the current time on the remote controller.
Procedure to switch between Fahrenheit and Celsius temperature units.
Unit automatically selects operation mode based on room temperature.
Provides cool air at the desired temperature.
Dehumidifies the room, with slight cooling effect.
Provides warm air at the desired temperature.
Adjusts the fan speed from Quiet to Super High.
Sets the vertical airflow direction.
Adjusts the horizontal airflow direction.
Allows saving and recalling preferred temperature, fan speed, and airflow settings.
Provides cooling with higher set temperature and swing airflow for energy saving.
Sets the unit to turn ON at a specified time.
Sets the unit to turn OFF at a specified time.
Instructions for cleaning the air filter every 2 weeks.
Maintenance for the air cleaning filter every 3 months and yearly replacement.
Procedure for removing and cleaning the front panel.
Troubleshooting common issues with the indoor unit operation.
Troubleshooting problems related to the remote controller.
Diagnosing unusual airflow or sounds from the unit.
Steps for properly shutting down and storing the unit for extended periods.
Checks and procedures before resuming operation after long-term storage.
Recommendations for suitable and unsuitable installation locations.
Guidelines for dedicated power supply and proper grounding.
Specifies the indoor and outdoor temperature ranges for cooling and heating.
