EasyManua.ls Logo

Mitsubishi Electric MSZ-GL06NA - User Manual

Mitsubishi Electric MSZ-GL06NA
92 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
M-Series - Controls (December 2016) 1
© 2016 Mitsubishi Electric US, Inc.
Due to continuing improvement, above specication may be subject to change without notice.
M-SERIES
Accessories
1. CONTROLS .......................................................................................................................................................................2
1-1. System Control..........................................................................................................................................................3
1-2. Wired Remote Controller [PAR-32MAA-J] ................................................................................................................ 6
1-3. Simple MA Remote Controller [PAC-YT53CRAU] ................................................................................................... 26
1-4. System Control Interface [MAC-333IF-E]................................................................................................................48
1-5. Wireless Adapter [PAC-WHS01WF-E] .................................................................................................................... 61
1-6. T-STAT Interface [PAC-US444CN-1] .......................................................................................................................73
1-7. Signal Receiver [PAR-SA9CA-E] ............................................................................................................................ 75
1-8. Wireless Remote Controller [PAR-FL32MA-E] ........................................................................................................ 79
1-9. Remote Sensor [PAC-SE41TS-E] ........................................................................................................................... 80
1-10. Connector Cable for Remote Display [PAC-SA88HA-E/PAC-725AD-E] ............................................................... 82
1-11. Remote Operation Adapter [PAC-SF40RM-E] ...................................................................................................... 86
1.12. System Control Interface [PAC-IF01MNT-E] ......................................................................................................... 90

Table of Contents

Other manuals for Mitsubishi Electric MSZ-GL06NA

Preview: Service Manual
Service Manual54 pages
Preview: Operating Instructions
Operating Instructions40 pages
Preview: Installation Manual
Installation Manual8 pages

Questions and Answers

  • P
    Paul GibsonAug 19, 2025
    Why Mitsubishi Electric Air Conditioner is not cooling enough?
    • S
      samuelcampbellAug 19, 2025
      Your Mitsubishi Electric Air Conditioner may not be cooling sufficiently due to several reasons. Ensure the temperature setting and fan speed are appropriate; try setting the fan to High or Super High. Check if the filters and the fan or heat exchanger of the indoor unit are clean. Also, make sure there are no obstructions blocking the air inlet or outlet of either the indoor or outdoor unit, and that all windows and doors are closed. Keep in mind that reaching the set temperature may take some time, depending on room size and ambient temperature.
  • M
    Mrs. Erin HernandezAug 21, 2025
    What to do if my Mitsubishi Electric MSZ-GL06NA unit cannot be operated?
    • H
      Holly KingAug 21, 2025
      If your Mitsubishi Electric Air Conditioner unit isn't operating, check whether the breaker is turned on and if the power supply plug is properly connected. Also, verify if the ON timer is set.
  • G
    grayashleyAug 23, 2025
    What to do if Mitsubishi Electric MSZ-GL06NA remote controller display is dim?
    • E
      Erin GreerAug 23, 2025
      If the display on your Mitsubishi Electric Air Conditioner remote controller is dim or not appearing, check if the batteries are exhausted and ensure they are inserted with the correct polarity (+, -). Also, make sure no buttons on other electric appliances' remote controllers are being pressed simultaneously.
  • R
    Richard CastilloAug 26, 2025
    What to do if my Mitsubishi Electric MSZ-GL06NA indoor control system is not reading data?
    • J
      Jacob CampbellAug 26, 2025
      If the Mitsubishi Electric Air Conditioner's indoor control system cannot properly read data in the nonvolatile memory of the indoor electronic control P.C. board, you should replace the indoor electronic control P.C. board.
  • V
    vwilkinsonAug 28, 2025
    What to do if my Mitsubishi Electric MSZ-GL06NA Air Conditioner has other abnormality?
    • A
      Anthony SnyderAug 28, 2025
      If your Mitsubishi Electric Air Conditioner shows other abnormality, check the stop valve, the 4-way valve and check the abnormality in detail using the failure mode recall function for outdoor unit.
  • T
    Terri OlsonAug 30, 2025
    Why does my Mitsubishi Electric Air Conditioner smell strange?
    • C
      Candace ThompsonAug 30, 2025
      If the air from your Mitsubishi Electric Air Conditioner smells strange, start by checking if the filters, fan, and heat exchanger of the indoor unit are clean. It's also possible that the unit is drawing in odors from the surrounding environment (such as walls, carpets, furniture, or cloth) and circulating them with the air.
  • C
    Charles MedinaSep 1, 2025
    Why does my Mitsubishi Electric MSZ-GL06NA stop for 10 minutes during heating?
    • C
      Cesar RuizSep 1, 2025
      The Mitsubishi Electric Air Conditioner may stop for about 10 minutes during heating because the outdoor unit is defrosting. This process can take up to 10 minutes. This typically occurs when the outside temperature is very low and the humidity is high, leading to frost formation.
  • K
    Kevin HolmesSep 3, 2025
    Why Mitsubishi Electric MSZ-GL06NA Air Conditioner air flow direction changes by itself?
    • D
      David FryeSep 3, 2025
      The airflow direction in your Mitsubishi Electric Air Conditioner may change automatically for a couple of reasons. In COOL or DRY mode, if the unit blows air downward for 0.5 to 1 hour, it will automatically adjust to blow upward to prevent condensation and dripping. Also, during heating, the horizontal vane will automatically set to a horizontal position if the airflow temperature is too low or when defrosting is in progress.
  • K
    katherine82Sep 5, 2025
    Why does my Mitsubishi Electric Air Conditioner unit restart on its own?
    • B
      brendagreenSep 5, 2025
      Mitsubishi Electric Air Conditioner models have an auto-restart function. If the unit was not stopped with the remote controller before the main power was turned off, it will automatically restart in the same mode it was in before the power shutoff.
  • F
    Frank Elliott DDSSep 7, 2025
    Why Mitsubishi Electric MSZ-GL06NA discharges mist?
    • W
      william51Sep 7, 2025
      Mist may be discharged from the air outlet of your Mitsubishi Electric Air Conditioner because the cool air from the unit rapidly cools the moisture in the room, causing it to turn into mist.

Summary

1. CONTROLS

1-1. System Control

Manages multiple indoor units centrally or individually via M-NET communication control.

1-2. Wired Remote Controller [PAR-32 MAA-J]

Advanced MA remote controller with large dot liquid crystal display for multi-language and weekly timer functions.

1-3. Simple MA Remote Controller [PAC-YT53 CRAU]

Controller enabling setting of certain indoor unit functions, like static pressure, for CITY MULTI series.

1-4. System Control Interface [MAC-333 IF-E]

Enables centralized control via M-NET and use as wired remote controller for multiple air conditioners.

1-5. Wireless Adapter [PAC-WHS01 WF-E]

Allows indoor unit communication with kumo cloud™ app and web via Wi-Fi.

1-6. T-STAT Interface [PAC-US444 CN-1]

Adapter inputting signals from open/close switch and outputting ON/OFF to back-up heater.

1-7. Signal Receiver [PAR-SA9 CA-E]

Enables the use of a wireless remote controller with the system.

1-8. Wireless Remote Controller [PAR-FL32 MA-E]

Wireless remote controller for P series and SEZ models, requiring a receiver.

1-9. Remote Sensor [PAC-SE41 TS-E]

Enables picking up room temperature at a remote position.

1-10. Connector Cable for Remote Display [PAC-SA88 HA-E;PAC-725 AD-E]

Adapter enabling control of multiple units with a remote control display.

1-11. Remote Operation Adapter [PAC-SE55 RA-E]

Extracts non-voltage contact output for operation/error signals and operation/stop input.

1-12. System Control Interface [PAC-IF01 MNT-E]

Connects A-control MXZ models to M-NET through optional M-NET converter.

Mitsubishi Electric MSZ-GL06NA Specifications

General IconGeneral
BrandMitsubishi Electric
ModelMSZ-GL06NA
CategoryAir Conditioner
LanguageEnglish

Related product manuals