To Next PageTo Next Page
Need help?Do you have a question about the Mitsubishi Electric MUZ-FS06NA and is the answer not in the manual?
General| Category | Air Conditioner |
|---|---|
| Series | MSZ-FS |
| Cooling Capacity | 6, 000 BTU/h |
| Heating Seasonal Performance Factor (HSPF) | 10.0 |
| Refrigerant | R410A |
| Operating Temperature (Cooling) | 14°F to 115°F |
| Power Supply | 208/230V, 1 Phase, 60Hz |
| Sound Level | 19 dB(A) (Indoor, Quiet Mode) |
Detailed performance metrics for cooling and heating operations.
Graphical representation of cooling and heating performance under various conditions.
Pressure data for cooling and heating modes based on ambient conditions.
Key operating parameters and specifications for different models.
Control logic for the outdoor fan motor, interlocking with the compressor.
Control logic for the reversing valve coil during heating and cooling modes.
Table showing sensor purpose and their relation to actuators.
Adjusting the defrost finish temperature by modifying a jumper.
Activating pre-heat control to prevent compressor startup issues in low temperatures.
Safety precautions and checks before starting troubleshooting procedures.
Procedure to recall and identify past failure modes using indoor unit indicators.
Table correlating LED indications with abnormal points, conditions, and remedies.
Resistance and voltage criteria for checking major components like sensors, motors, and coils.
Step-by-step diagnostic flows for common issues like inverter, compressor, and power supply.
Diagrams showing test points and voltage references on the inverter P.C. board.
Step-by-step guide for removing the external cabinet and panels.
Instructions for safely removing the inverter assembly and P.C. board.
Procedure for removing the Reversing Valve (R.V.) coil.
Steps to remove various thermistors from the unit.
Instructions for removing the outdoor fan motor assembly.
Steps for removing the compressor and the 4-way valve.
Guide for cabinet removal specific to FS15/18 models.
Instructions for removing the inverter assembly and P.C. board for FS15/18 models.
Steps to remove various thermistors for FS15/18 models.
Instructions for removing the outdoor fan motor for FS15/18 models.
Steps for removing the compressor and 4-way valve for FS15/18 models.
