To Next PageTo Next Page
Need help?Do you have a question about the Mitsubishi Electric MUZ-FS06NAH and is the answer not in the manual?
General| Brand | Mitsubishi Electric |
|---|---|
| Model | MUZ-FS06NAH |
| Category | Air Conditioner |
| Language | English |
Presents performance data for cooling capacity under various conditions.
Provides cooling performance curves showing capacity and power consumption based on operating conditions.
Details condensing pressure charts for cooling operation based on indoor/outdoor temperatures.
Lists standard operation data for cooling and heating, including capacity, power, and airflow.
Shows how cooling and heating capacity/input are affected by inverter frequency.
Details the procedure for operating the unit in fixed-frequency test run mode.
Describes the control logic for the outdoor fan motor, interlocking with compressor operation.
Explains the control of the reversing valve (R.V. coil) for heating and cooling modes.
Illustrates the relationship between system sensors and various actuators.
Details how to change the defrost finish temperature settings.
Explains how to activate the pre-heat control to prevent compressor start-up issues.
Provides essential safety precautions and checks before performing troubleshooting.
Describes how to recall and interpret failure modes for troubleshooting.
A table correlating symptoms, LED indications, conditions, and remedies for troubleshooting.
Provides resistance and measurement criteria for diagnosing main components.
Outlines systematic troubleshooting procedures for various system issues.
Illustrates test points and voltage specifications on the inverter P.C. board.
Procedure for removing the outer cabinet of the unit.
Guide to removing the inverter assembly and its P.C. board.
Procedure for removing the reversing valve (R.V.) coil component.
Instructions for removing thermistors and heat exchanger components.
Instructions for safely removing the outdoor fan motor assembly.
Steps to detach and remove the compressor and the 4-way valve.
Procedure for removing the outer cabinet of the unit.
Guide to removing the inverter assembly and its P.C. board.
Instructions for removing thermistors and heat exchanger components.
Steps for removing the outdoor fan motor assembly.
Procedure for removing the compressor and the 4-way valve.
