Mitsubishi Electric PAC-SE51CRA Installation Manual

MITSUBISHI ELECTRIC
Building Air-Conditioning Control System
Remote Controller
lnstallation Manual
PAC-SE51 CRA
This manual contains only the lnstallation procedure for the remote controller. For informatlon about how to wlre and lnstall alr conditionlng
units, see their installatlon manua;,;.ls,,_. ~~~~----~
For your safety, thoroughly read (11 Safety Precautlons) descrlbed below before lnstalllng the remote controller correctly.
( 1 1 Safety Precautions )
• The following two symbols are used to denote dangers that may Ье caused Ьу lncorrect use:
&WARNING
Thls symbol denotes what could lead to serlous lnjury or death lf the remote controller is mlsused.
&CAUTION
This symbol denotes what could lead to personal lnjury or property damage lf the remote controller ls mlsused.
• After reading thls lnstallation manual, keep it in а safe place where the user can refer to lt whenever necessary.
Make sure that thls manual ls forwarded to the next user.
&WARNING
Aak your dealer or technlcal repreaentatlve to lnatall the unlt.
Any deflclency caused Ьу your own lnstallatlon may result ln an electrlc
shock or flre.
lnatall ln а place whlch la atrong enough to wlthatand the welght of
the PAC-SE51CRA.
Any lack of strength may cause the PAC-SE51 CRA to fall down, resultlng
ln personal lnjury.
Flrmly connect the wlrlng ualng the apeclfled саЫеа. Carefully check
that the саЫеа do not exert any force оп the termlnala.
lmproper wlrlng connectlons may produce heat and posslЫy а flre.
Never modlfy or repalr the PAC-SE51CRA Ьу youraelf.
Any deflclency caused Ьу your modlflcatlon or repalr may result ln an elec-
trlc shock or tlre.
Consult wlth your dealer about repalrs.
Enaure that lnatallatlon work la done correctly followlng thla lnatalla-
tlon manual.
Any deflclency caused Ьу lnstallatlon may result ln an electrlc shock or flre.
АН electrlcal work muat Ье performed Ьу а Jlcenaed technlclan, ac-
cordlng to local regulatlona and tha lnatructlona glven ln thla manual.
Any lack of electrlc clrcult or any deflclency cauaed Ьу lnstallatlon may re-
sult ln an electrlc shock or flre.
Do not move and re-lnatall the PAC-SE51 CRA youraelf.
Any deflclency caused Ьу lnstallatlon may result ln an electrlc shock or flre.
Ask your dlstrlbutor or speclal vendor for movlng and lnstallatlon.
&CAUTION
Do not lnatall ln any place expoaed to flammaЫe gaa leakage.
Flammable gases accumulated around the body of PAO-SE51CRA may
cause an exploslon.
Do not uae ln any apeclal envlronment.
Uslng ln any place exposed to oll (lncludlng machlne oll), steam and sulfu-
rlc gas may deterlorate the performance slgnlflcantly or glve damage to the
component parts.
Wlre ао that lt doea not recelve any tenalon.
Tenslon may cause wlre breakage, heatlng or flre.
Completely aeal the wlre lead-ln port wlth putty etc.
Any dew, molsture. cockroaches, lnsects enterlng the unlt may cause an
electrlc shock or а maltunctlon.
Do not waah wlth water.
Dolng so may cause an .electrlc shock or а malfunctlon.
Do not lnatall ln any place at а temperature of more than 40"С or leaa
than О
0
С or axpoeed to dlrect aunllght.
(2
Specification )
Do not lnatall ln any ateamy place auch а bathroom or kltchen.
Avold any place where molsture ls condensed lnto dew. Dolng so may cause
an electrlc shock or а malfunctlon.
Do not lnatall ln any place where acldlc or alkallne aolutlon or apeclal
apray are often uaed.
Dolng so may cause an electrlc shock or malfunctlon.
Uae atandard wlre• ln compllanoe wlth the current capaclty.
А fallure to thls may result ln an electrlc leakaga. heatlng or flre.
Do not touch any РСВ (Prlnted Clrcult Board) wlth your handa or wlth
toola. Do not allow duat to collect on the РСВ.
Dolng so may cause flre or an electrlc shock.
Do not touch any control button wlth your wat handa.
Dolng so may cause an electrlc shock or а malfunctlon.
Do not preaa any control button ualng а aharp objact.
Dolng so may cause an electrlc shock or а maltunctlon.
Never contact the powar aupply wlth the control wlrlng termlnala.
Dolng so wlll certalnly cause the controller to catch flre.
Source power requlrement
lnput voltage DC17 V - DСЗО V, 0.02 А
Power recelved from outdoor unlt via M-NET transmlsslon llne.
lnterface condition for transmission line
M-NET transmlsslon line ; DСЗО V+AMI slgnal (DC±S V)
Number of M-NET controlled indoor
1 - 16
unlt controlled Ьу PAC-SE51 САА
Envlronmental condition
Temperature
1 Operating
о - 40°С
Non operatlng
о - 70°С
Humlditv 1 30 - 90%RH (No condensation)
Dlmenslons
120 (Hloh) х 70 (Width) х 8<41> (Depth) mm
Weiaht
О.15 ka
(з
Checklng the Supplied Parts )
Check that the Ьох lncludes the followlng parts ln addltlon to thls lnstallatlon manual:
Remote Controller Model Name
Enclosed Parts
(1) Remote controller .........•.. " ............ "" ........................................ " ................ " ................................. 1
PAC-SE51CRA
(2) Cross-recessed pan-head screws ........... " ................................................ " .................. " .. " ........... 2
(З) Operatlon manual ..... " ...........................•.............. " ... " " ..•.•......•.................. ". .... .. . ... ...... .. ..... .. .. . .. .. 1
NOTE:
The parts llsted below must Ье purchased separately.
(1) СаЫе connectlng the remote controller to the lndoor unlt:
Use the саЫе speclfled below.
1 СаЫе tvpe 1 VCTF or CW (2-core): 0.75 - 1.25 mm• or equlvalent 1
* CVV ls а control саЫе whlch is sheathed ln polyvlnyl chlo-
rlde wlth polyvlnyl insulated wires inslde.
NOTE:
lf you need to use а саЫе extension longer than 1 О
meters, select an electrlc wire that meets the follow-
lng speclflcations:
Wire specification ..... VCTF or CVV (2-core):
1 .25 mm
2
or equlvalent

Mitsubishi Electric PAC-SE51CRA Specifications

General

Type	Remote Control
Model	PAC-SE51CRA
Brand	Mitsubishi Electric
Display	LCD
Power Source	Battery
Compatibility	Mitsubishi Electric air conditioning units