Mitsubishi Electric PAC-WHS01WF-E User Manual

TECHNICIAN MANUAL
FOR INSTALLER
2.10
®
ATTENTION
● The Wireless Interface 1 and 2
must
connect to a 2.4 GHz Wi-Fi
®
network.
● The Wireless Interface 1 and 2 will
not
work on a 5 GHz Wi-Fi network.
○ The Wireless Interface 1 and 2 can only connect to Wi-Fi channels 1-11.
● For the best performance connect the Wireless Interface 1 and 2 to a 2.4 GHz only SSID, but there
are some multi-band Wi-Fi networks that can correctly manage a 2.4 GHz only device.
○ Please verify if your multi-band Wi-Fi router can manage 2.4 GHz only devices.
Note: The set up of the Wireless Interface to the kumo cloud app requires a Wi-Fi network with a live internet
connection.
NOTE
● This manual reects the installation of the Wi-Fi Interface (PAC-WHS01WF-E), Wireless Interface 1
(PAC-USWHS002-WF-1), and Wireless Interface 2 (PAC-USWHS002-WF-2) for the 2.12 and 2.14
kumo cloud app release updates.
● This manual has not been updated yet to show the additions of the 2.12 and 2.14 updates, but the
manual will be updated in the near future.
Note: The changes in 2.12 and 2.14 were minor and did not change the overall way the equipment is installed.

Mitsubishi Electric PAC-WHS01WF-E Specifications

General

Category	Control Systems
Communication	Wi-Fi
Mobile App	Yes
Operating Temperature	0°C to 50°C
Compatibility	Mitsubishi Electric Air Conditioners

Summary

kumo cloud® Installation and Setup

Getting Started: App and Account Creation

Download the kumo cloud app and create a user account for the system.

Site Connection and Unit Configuration

Connect the site to a wireless network, add indoor units, and configure zones.

Finalizing Installation and Ownership Transfer

Complete setup, save unit settings, and transfer ownership to the homeowner.

kumo cloud® Operation and Advanced Settings

Performing Test Runs and Zone Management

Conduct test runs to verify operation and manage configured zones.

System Settings and Customization

Adjust advanced unit settings, set prohibits, and configure time zones.

kumo cloud® Accessories and Features

Wireless Sensor Integration

Add and configure Mitsubishi Electric Wireless Temperature and Humidity Sensors.

kumo station and Accessory Setup

Configure kumo station with accessories like backup heaters, humidifiers, etc.

System Management and Support

Airflow and Static Pressure Configuration

Set airflow and static pressure for ducted indoor units.

First Generation Interface Setup and Manual Configuration

Install older Wireless Interfaces and perform manual zone setup.

Maintenance, Troubleshooting, and FAQs

Manage maintenance, understand errors, and find answers to common questions.