To Next PageTo Next PageWhat does “ ” mean on my Mitsubishi Electric SLZ-KA50VAL Air Conditioner remote controller?
During central control, “ ” appears in the Mitsubishi Electric remote controller display and air conditioner operation cannot be started or stopped using the remote controller.
Why is the operation lamp flashing on my Mitsubishi Electric SLZ-KA50VAL Air Conditioner?
If the operation lamp near the receiver for the wireless remote controller on the Mitsubishi Electric indoor unit is flashing, the self-diagnosis function has operated to protect the air conditioner. Do not attempt to repair this equipment by yourself. Turn off the power switch immediately and consult your dealer. Be sure to provide the dealer with the model name.
Why is my Mitsubishi Electric SLZ-KA50VAL Air Conditioner remote controller display blank or faint?
If nothing appears in the display of your Mitsubishi Electric wireless remote controller, the display is faint, or signals are not received by the indoor unit unless the remote controller is close, the batteries are likely low. Replace the batteries and press the Reset button. If nothing appears even after the batteries are replaced, make sure that the batteries are installed in the correct directions (+, –).
What to do if my Mitsubishi Electric SLZ-KA50VAL Air Conditioner does not restart immediately?
If, when restarting the Mitsubishi Electric Air Conditioner soon after stopping it, it does not operate even though the ON/OFF button is pressed, wait approximately three minutes. The unit has stopped to protect the air conditioner.
What to do if an error code appears on my Mitsubishi Electric Air Conditioner remote controller?
If your Mitsubishi Electric Air Conditioner remote controller displays an error code, it indicates that the protection devices have operated to protect the air conditioner. Do not attempt to repair this equipment by yourself. Turn off the power switch immediately and consult your dealer. Be sure to provide the dealer with the model name and information that appeared in the remote controller display.
What to do if my Mitsubishi Electric SLZ-KA50VAL Air Conditioner stops without the ON/OFF button being pressed?
If your Mitsubishi Electric Air Conditioner stops without pressing the ON/OFF button, check if the off timer is set and press the ON/OFF button to restart operation. If the air conditioner is connected to a central remote controller, consult the concerned people who control the air conditioner. If “ ” appears in the remote controller display, consult the concerned people who control the air conditioner.
What to do if my Mitsubishi Electric SLZ-KA50VAL Air Conditioner operates without the ON/OFF button being pressed?
If your Mitsubishi Electric Air Conditioner operates without pressing the ON/OFF button, check if the on timer is set and press the ON/OFF button to stop operation. If the air conditioner is connected to a central remote controller, consult the concerned people who control the air conditioner. If “ ” appears in the remote controller display, consult the concerned people who control the air conditioner. Also, if the auto recovery feature from power failures has been set, press the ON/OFF button to stop operation.
General| Type | Ceiling Cassette |
|---|---|
| Cooling Capacity | 5.0 kW |
| Outdoor Unit Dimensions (W x H x D) | 800 x 550 x 285 mm |
| Refrigerant | R410A |
| Outdoor Unit Noise Level | 49 dB(A) |
| Power Supply | 220-240V, 50Hz |
| Indoor Unit Dimensions (W x H x D) | 570 x 570 mm |
| Indoor Unit Noise Level (Cooling) | 30 dB(A) |
