Chapter 9
268
Logic programming – Function blocks
Go to the Logic editor view and click on the Start force mode button. A dialog is
opened where you can enter the time after which the force mode will be
automatically left if no actions are taken.
Choose the desired time span from the drop box list and click OK. Force mode will
be activated and the background colour of the logic editor changes to orange.
While force mode is active, it is not possible to logout, to upload and compare a
configuration or to stop the safety controller.
Figure 258:
Dialog window when starting
force mode
Figure 259:
Logic editor with force mode
activated
Note
To Next Page
Loading...
