Mitsubishi Electric TC-24B - Operation Setting Procedures; Time and Schedule Management

30 31
Usage - Main Menu settings - Operation setting
1. Touch the
A [Date and Time] button on the [Time and Schedule] screen.
2. On the [Date and Time] screen, touch the
1 [Date] tab to set the date, or 2 [Time] tab to set the time.
3. Using the
3 buttons, set the following items: “Month/Date/Year” and “Hour/Minute/AM·PM”.
4. On each tab, select one of the three display formats by checking the
4 checkbox next to the desired
format.
5. Touch the button
5 to access the [Daylight saving changes] screen.
• Touching the button
6 displays a list of countries. Select your country.
Select “Not used“ if you do not use daylight saving time.
• If your county does not exist in the list, select “Manual”.
The buttons
7 become active. Touching the buttons 7 displays the date and time setting screen.
Set the start and end date/time.
Date and time setting screen Daylight saving time setting screen
6
7
6. Touch the 8 [Save] button.
• The initial date/time setting is 1/1/2013 12:00AM.
• If the clock is set forward, the operations that were scheduled to have taken place before the new
time will be cancelled.
• When the Daylight Saving Time goes in effect, the scheduled operations or the Setback operations
scheduled for the skipped hour cannot be executed.
• When "Clock Setting Signal" is set to OFF on the [Initial Settings 1/Basic System] screen under the
Service Menu, the daylight saving time function is not available.
Usage - Main Menu settings
Operation setting
1
Time and Schedule
Main Menu > Operation Setting
1
2
3
Main Menu > Operation Setting > Time and Schedule
A
B
C
A Setting the date, time, and display format
Main Menu > Operation Setting > Time and Schedule > Date and Time
Date tab
4
3
1
5
Time tab
4
8
3
2
5