Mitsubishi Electric TRANE TPEFYP024MA144A User Manual (English)

Other manuals for Mitsubishi Electric TRANE TPEFYP024MA144A

Questions and Answers:

M
Melissa RichardsAug 6, 2025
Why my Mitsubishi Electric Air Conditioner does not cool or heat enough?
- D
  Daniel RandallAug 6, 2025
  There might be several reasons why your Mitsubishi Electric Air Conditioner isn't cooling or heating adequately: * The temperature might not be adjusted properly. Check the set and inlet temperatures on the display and adjust the settings. * The filter could be clogged with dust and dirt. Clean the filter. * Obstructions might be present at the air inlet or outlet of the indoor or outdoor units. Remove any obstacles. * Windows or doors might be open. Ensure they are closed.
T
Tyrone PhillipsAug 10, 2025
What to do if my Mitsubishi Electric TRANE TPEFYP024MA144A Air Conditioner does not run?
- K
  Kimberly NewmanAug 10, 2025
  If your Mitsubishi Electric Air Conditioner isn't running, consider these potential causes: * There may have been a power failure. If so, press the [ON/OFF] button after power is restored. * The power supply might be turned off. Ensure the power supply is turned on. * The fuse in the power supply could be blown. Replace the fuse. * The earth leakage breaker might have tripped. Reset the earth leakage breaker.
J
Jacob YoungAug 14, 2025
What to do if my Mitsubishi Electric Air Conditioner runs briefly, but soon stops?
- C
  Calvin HansonAug 14, 2025
  If your Mitsubishi Electric Air Conditioner starts and then stops quickly, it could be due to: * Obstacles at the air inlet or outlet of the indoor and outdoor units. Remove any obstructions, then restart the unit. * A dirty filter filled with dust and dirt. Clean the filter before restarting.
R
richard98Aug 19, 2025
Why cool or warm air does not come out of my Mitsubishi Electric TRANE TPEFYP024MA144A?
- A
  Allen StevensAug 19, 2025
  If your Mitsubishi Electric Air Conditioner is not emitting cool or warm air, it could be because: * The restart-preventing circuit is in operation for 3 minutes. Wait for a while, as this circuit protects the compressor and may delay its start. * The indoor unit operation was restarted during heating and defrosting. Allow the unit to complete the defrosting operation before heating begins.
O
ortizjustinAug 23, 2025
Why does my Mitsubishi Electric TRANE TPEFYP024MA144A Air Conditioner make noise after stopping?
- J
  Jennifer OdomAug 25, 2025
  If you hear exhaust sounds and motor rotation after your Mitsubishi Electric Air Conditioner stops, it's likely because when other indoor units are engaged in cooling operation, the machine stops after running a drain-up mechanism for 3 minutes when air-cooling operation is stopped. Wait for 3 minutes.
I
Isaac OliverAug 27, 2025
Why my Mitsubishi Electric Air Conditioner makes intermittent noise after being turned off?
- L
  Lindsay BrooksAug 27, 2025
  The intermittent noise from your Mitsubishi Electric Air Conditioner after it's turned off is likely due to drained water being processed when other indoor units are engaged in cooling operation. The drain-up mechanism initiates a draining operation. It should stop soon. If the noise occurs more than 2-3 times in an hour, ask for repair service.
B
bowensAug 31, 2025
Why warm air comes out intermittently from my Mitsubishi Electric Air Conditioner during fan operation?
- N
  navarrolauraAug 31, 2025
  The intermittent warm air from your Mitsubishi Electric Air Conditioner, even when the thermostat is off or during fan operation, happens because when other indoor units are engaged in heating operation, the control valves are opened and closed from time to time to maintain the stability of the system. It should stop soon. If the room temperature rises uncomfortably high in a small room, stop operation.

Mitsubishi Electric TRANE TPEFYP024MA144A Specifications

General

Category	Air Conditioner
Brand	Mitsubishi Electric TRANE
Model	TPEFYP024MA144A
Refrigerant	R410A
Cooling Capacity	24000 BTU/h
Seasonal Energy Efficiency Ratio (SEER)	16
Power Supply	208-230V, 60Hz