To Next PageTo Next Page
Need help?Do you have a question about the Mitsubishi Electric TRANE TPKA0A 1KA70 Series and is the answer not in the manual?
General| Category | Air Conditioner |
|---|---|
| Cooling Capacity | 7.0 kW |
| Heating Capacity | 8.0 kW |
| Refrigerant | R410A |
| Power Supply | 220-240 V, 50 Hz |
| Outdoor Unit Noise Level | 52 dB |
| Series | TPKA0A 1KA70 Series |
Precautions related to the installation environment and potential hazards.
Precautions for safe handling during installation or relocation.
Essential safety measures for electrical work.
Key steps and checks before starting the test run.
Specifies clearance dimensions for indoor unit installation.
Lists and describes the accessories included with the indoor unit.
Details on installing the wall mounting fixture.
Guidance on positioning the mounting fixture and drilling holes.
Instructions for drilling the wall hole for piping.
Securing the wall mounting fixture correctly.
Procedures for embedding pipes within the wall.
Steps for preparing the indoor unit for installation.
Attaching the L-shaped pipe to the indoor unit.
Instructions for installing the lower piping.
Procedure for checking refrigerant leaks at the connection.
Steps for preparing piping and wiring for installation.
Instructions for rear and lower piping arrangements.
Instructions for left and left rear piping arrangements.
Steps for physically mounting the indoor unit.
Mounting the unit with rear and lower piping.
Mounting the unit with left and left rear piping.
General precautions for refrigerant piping installation.
Specific precautions for R410A refrigerant.
Procedures for connecting refrigerant pipes.
Guidance on routing refrigerant and drain piping.
Steps for connecting refrigerant pipes to the indoor unit.
How to store piping within the unit's space.
Detailed instructions for drainage piping installation.
Preparation steps for left and left rear piping.
Storing the drain hose within the unit.
Procedure to verify correct drainage.
Procedures for electrical connections within the indoor unit and CN105.
Wiring diagrams for indoor unit power from outdoor unit.
Setup for both wired and IR wireless remote controllers.
Setup procedures for wired remote controllers.
Setup procedures for IR wireless remote controllers.
On-unit function configuration, including wired remote.
Setting functions using the wired remote controller.
Advanced settings via remote, including voltage, unit ID, and modes.
Pairing IR wireless remote controllers to units.
Setting power voltage and unit number via remote.
How to select different operational modes.
Pre-test run checks and precautions.
General instructions for performing the test run.
Steps for performing a self-check.
Troubleshooting error codes for outdoor units.
Procedures for handling error codes and wait messages.
Introduction to displaying maintenance data.
Steps to navigate to the smooth maintenance screen.
How to view specific maintenance data points.
