47
Commissioning and adjusting
SG Ready
This function can only be used in mains networks that support
the "SG Ready"-standard .
Make settings for the function "SG Ready" here.
Low price mode means that the electricity supplier has a low
tariff and the system uses this to reduce costs.
Over capacity mode means that the electricity supplier has set
the tariff very low and the system uses this to reduce the costs
as much as possible.
affect room temperature
Here you set whether room temperature should be affected
when activating "SG Ready".
With low price mode of "SG Ready" the parallel off set of the
indoor temperature is increased by "+1". If a room sensor is
installed and activated, the desired room temperature increases
by 1 °C.
With over capacity mode of "SG Ready" the parallel off set for
the indoor temperature is increased by"+2".
If a room sensor is installed and activated, the desired room
temperature increases by 2 °C.
affect hot water
Here you set whether the temperature of the hot water should
be aff ected when activating "SG Ready".
With low price mode on "SG Ready" the stop temperature of
the hot water is set as high as possible at only compressor
operation (immersion heater not permitted).
With over capacity mode of "SG Ready" the hot water is set to
"luxury" (immersion heater permitted).
affect cooling (accessory required)
Here you set whether room temperature during cooling
operation should be aff ected when activating "SG Ready".
With low price mode of "SG Ready" and cooling operation the
indoor temperature is not aff ected.
With over capacity mode of "SG Ready" and cooling operation
the parallel off set for the indoor temperature is reduced by"-1".
If a room sensor is installed and activated, the desired room
temperature decreases by 1 °C.
NOTE
The function must be connected to two AUX inputs and
activated in menu 5.4.
To Next Page
Loading...
Need help?
General
