To Next PageTo Next PageWhat to do if my Mitsubishi Heavy Industries SRF35ZJX-S doesn't restart after a power cut?
If your Mitsubishi Heavy Industries Air Conditioner doesn't restart after a power cut, and power has been restored, it is because the auto restart function is not set. Use the remote control to start the operation again.
Why is there no airflow when starting DRY operation on Mitsubishi Heavy Industries SRF35ZJX-S Air Conditioner?
If airflow isn't expelled when starting the DRY operation on your Mitsubishi Heavy Industries Air Conditioner, wait, as the indoor fan may stop.
Why isn't my Mitsubishi Heavy Industries SRF35ZJX-S blowing air when heating?
If airflow isn't expelled when starting the HEATING operation on your Mitsubishi Heavy Industries Air Conditioner and the RUN light blinks slowly, allow 2 to 5 minutes for the indoor heat exchanger to warm up.
How to improve poor cooling or heating in my Mitsubishi Heavy Industries Air Conditioner?
If your Mitsubishi Heavy Industries Air Conditioner isn't cooling or heating well, make sure the thermostat is set to a suitable temperature, the air filter is clean, and all doors and windows are closed.
Why is my Mitsubishi Heavy Industries Air Conditioner not cooling or heating properly?
If your Mitsubishi Heavy Industries Air Conditioner isn't cooling or heating well, first, adjust the thermostat to a more suitable temperature. Also, check to ensure the air filter is clean and that all doors and windows are closed.
Why is there moisture on the Mitsubishi Heavy Industries SRF35ZJX-S outlet grills?
If moisture forms on the air outlet grills of your Mitsubishi Heavy Industries Air Conditioner, it may be because the unit is operated for a long time in high humidity, causing moisture to form and start dripping.
Why does the RUN light stay on after stopping my Mitsubishi Heavy Industries SRF35ZJX-S?
If the RUN light stays on even though operation was stopped on your Mitsubishi Heavy Industries Air Conditioner, the RUN light illuminates during CLEAN operation and turns off when CLEAN operation ends.
Why no airflow when starting DRY operation on my Mitsubishi Heavy Industries SRF35ZJX-S?
If airflow is not blown out when starting the DRY operation of your Mitsubishi Heavy Industries Air Conditioner, the indoor fan may stop to prevent re-evaporation of dehumidified moisture and to save energy.
Why is my Mitsubishi Heavy Industries SRF35ZJX-S Air Conditioner not cooling effectively?
If your Mitsubishi Heavy Industries Air Conditioner isn't cooling well, check if there is direct sunlight entering the room, if there is a heat source in the room, or if there are too many people in the room.
Why does my Mitsubishi Heavy Industries SRF35ZJX-S Air Conditioner blow cold air during heating?
If your Mitsubishi Heavy Industries Air Conditioner has airflow that is not blown out for 5 to 10 min, or blows out not warm wind for a moment at HEATING operation, and the RUN light blinks slowly, the unit is likely defrosting automatically because the outdoor temperature is low and humidity is high. Please wait.
General| Cooling Capacity | 3.5 kW |
|---|---|
| Heating Capacity | 4.0 kW |
| Indoor Unit Dimensions (W x H x D) | 845 x 275 x 228 mm |
| Outdoor Unit Dimensions (W x H x D) | 780 x 540 x 269 mm |
| Refrigerant | R32 |
| Energy Efficiency Ratio (EER) | 3.50 |
| Power Supply | 220-240V, 50Hz |
| Energy Efficiency Ratio (Cooling) | 3.50 |
