To Next PageTo Next PageWhy is there no airflow when starting the heating on my Mitsubishi Heavy Industries SRF35ZJX-S?
If your Mitsubishi Heavy Industries Air Conditioner is not blowing airflow when starting the HEATING operation and the RUN light blinks slowly, it's likely stopped to prevent cold air from blowing until the indoor heat exchanger warms up, which usually takes 2 to 5 minutes.
How to restart Mitsubishi Heavy Industries Air Conditioner after power outage?
If, after a power cut, your Mitsubishi Heavy Industries Air Conditioner doesn't restart even after power is restored, use the remote control to start the operation again.
What to do if Mitsubishi Heavy Industries SRF35ZJX-S Air Conditioner is not cooling enough?
If your Mitsubishi Heavy Industries Air Conditioner isn't cooling adequately, check if direct sunlight is entering the room. Also, identify and eliminate any heat sources present, and consider if there are too many occupants in the room.
How to fix a Mitsubishi Heavy Industries SRF35ZJX-S Air Conditioner when remote control signals are not received?
If remote control signals are not received by your Mitsubishi Heavy Industries Air Conditioner, it may be because the signal receiver is exposed to direct sunlight or other bright light. If so, cut out the sunlight or reduce the other light.
What to do if my Mitsubishi Heavy Industries Air Conditioner does not work?
If your Mitsubishi Heavy Industries Air Conditioner isn't working, check if the power switch is turned on, if the timer is set in the “ON” position, and if there is a power failure or a blown fuse.
General| Cooling Capacity | 3.5 kW |
|---|---|
| Heating Capacity | 4.0 kW |
| Indoor Unit Dimensions (W x H x D) | 845 x 275 x 228 mm |
| Outdoor Unit Dimensions (W x H x D) | 780 x 540 x 269 mm |
| Refrigerant | R32 |
| Energy Efficiency Ratio (EER) | 3.50 |
| Power Supply | 220-240V, 50Hz |
| Energy Efficiency Ratio (Cooling) | 3.50 |
