– 6 –
AUTO HI MED LO
Temperature adjustment during AUTO
■
Air temperature adjustment is possible even during automatic operation. There are 6 levels of adjustment possible with the button or the button.
AUTO mode operation procedure
■
Automatically selects the operation mode (COOL, HEAT, DRY) depending on the room temperature when switched on.
Air flow direction adjustment
procedure.
Page 8
1
When a change in temperature is desired.
Press the or button.
• Air is not blowing out during the op-
eration.
Page 18
• If you don’t want the AUTO mode program, change to
COOL, HEAT or DRY instead of AUTO.
Page 7
AUTO mode can be
operated by simply
pressing the ON/OFF
button.
To stop: Press the ON/OFF button.
■ Each time the
button is pressed, the switch over occurs in the following order
–6 → –5 → ............ –1 → ±0 → +1 ............ +6.
When +6 is indicated, even if the button is pressed, the indicator does not change.
■ Each time the button is pressed, the switch over occurs in the following order
+6 → +5 → ............ +1 → ±0 → –1 ............ –6.
When –6 is indicated, even if the button is pressed, the indicator does not change.
When the unit is not in AUTO mode:
Press MODE button.
Move the [ mark] to the (Auto) position.
Aim the remote control at the air-conditioner.
Press the ON/OFF button.
1
2
When it is a little cold
Press the
button.
When it is a little hot
Press the
button.
Operation capacity by your choice FAN SPEED
Set automatically by microcomputer AUTO
Powerful operation with high capacity HI
Standard operation MED
Energy-saving operation LO
About FAN SPEED
Press the FAN SPEED button.
Move the [ mark] to the desirable fan speed position.
NOTE
■ You can choose the capacity of your air-conditioner when heating or cooling.
RKX012A014_En.p65 06.9.19, 9:33 AM6
To Next Page
Loading...
Need help?
General
