8-6 4WD operation <FG models>
NOTE:
• You do not need to depress the clutch pedal
when switching from the 2WD-HIGH setting to
the 4WD-HIGH setting or vice versa.
• The mode-range setting cannot be switched
from 4WD-LOW to 2WD-HIGH. The 4WD-HIGH
setting must be selected before such switching
can take place.
• If it is difficult to switch from 2WD mode to 4WD
mode and vice versa, release the accelerator
pedal and then depress it again lightly. This will
facilitate the switching.
• During switching from 4WD mode to 2WD
mode, the system may remain in 4WD mode
even after the indicator lamp has gone out.
If this happens, release the accelerator pedal
and depress it again lightly. The switching will
then take place.
• “4WD-HIGH” to/from “4WD-LOW”
1. Stop the vehicle and depress the clutch pedal.
2. Move the HIGH-LOW lever while pressing the
button on it to the HIGH range position or
LOW range position .
3. After moving the lever fully to the HIGH range or
LOW range position, make sure that the
indicator lamp has come on or gone off and then
release the clutch pedal. Check that the lever is
locked properly by trying to move it back and
forth without pressing the button.
Z11342
Z11343
Z12575
FE_FG.book Page 6 Wednesday, January 14, 2009 7:08 PM
To Next Page
Loading...
Need help?
General
