12-9
4 Checking locking of the cab
When the cab is lowered down, the state of locking
should be checked as follows. If incomplete locking
is identified, repeat the cab tilting procedure and
lower once again. If incomplete locking still exists,
never drive the vehicle and contact your authorized
dealer.
1. Confirm that the latch is fully engaged with
the pin . Also confirm that lever B does not
move when it is pulled.
2. Confirm that the cab does not rise up when lever
C is pulled.
3. Turn the starter switch to the “ON” position, and
make sure that the warning lamp is not lit.
If the warning lamp lights and the buzzer
sounds, the cab is not locked completely. If this
happens, tilt up the cab, lower it, and lock it
again.
Z18603
Z11895
FE_FG.book Page 9 Wednesday, January 14, 2009 7:08 PM
To Next Page
Loading...
Need help?
General
