EasyManuals Logo

Mitsubishi 2010 Fuso FE User Manual

Mitsubishi 2010 Fuso FE
370 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #195 background imageLoading...
Page #195 background image
12-38 Simple inspection and service
6.1 Check
The fluid level should be between the “MAX” and
“MIN” lines on reservoir tank . Check whether the
reservoir tank contains foreign matter. If you see
foreign matter in the reservoir tank, have the reser-
voir tank inspected and cleaned by an authorized
dealer.
NOTE:
The warning lamp is illuminated when the
brake fluid level drops below the “MIN” line.
CAUTION
Do not open cap of reservoir tank for inspec-
tion purposes.
6.2 Adding fluid
1. If the fluid level is lower than the “MIN” line,
remove cover , clean the surfaces around cap
of reservoir tank, open cap , and add the rec-
ommended brake fluid up to the “MAX” line.
2. Close the cap firmly.
CAUTION
Be careful not to exceed the “MAX” line when
adding brake fluid.
WARNING
The container used for adding brake fluid
should be a clean one free of moisture,
mineral oil, and dust.
Be extremely careful not to let dust and
other foreign matter enter the reservoir
tank, as foreign matter in the tank could
cause a failure of the brake system.
If you see foreign matter in the reservoir
tank, have it checked and cleaned by an
authorized dealer.
If the fluid level is unusually low, there is a
fluid leak in the brake line. In this case,
have your vehicle inspected at an autho-
rized dealer.
Z12050
Z12051
FE_FG.book Page 38 Wednesday, January 14, 2009 7:08 PM

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mitsubishi 2010 Fuso FE and is the answer not in the manual?

Mitsubishi 2010 Fuso FE Specifications

General IconGeneral
BrandMitsubishi
Model2010 Fuso FE
CategoryTrucks
LanguageEnglish

Related product manuals