13-10 Useful advice for emergencies
1.2 Removal and installation of high-current
fuse box cover
1. Pull down the clamps , then lift the cover
straight upward to remove it.
2. To install the cover, place it on the box and press
it straight downward. Align the holes of the clips
with the protrusions . While still pressing the
cover downward, retain it with the clamps.
CAUTION
When installing the high-current fuse box cover,
be sure to retain it with the clamps while press-
ing it straight downward. Pushing the cover
toward the inside of the vehicle with excessive
force could break it.
1.3 Inspection and replacement of blade-type
fuses
1. Place the starter switch in the “LOCK” position
and turn all other switches OFF.
2. To remove the fuse that is to be replaced, grip it
using the fuse puller in the fuse box. The
amperage and protected circuit of each fuse are
shown on the inside of the fuse box cover and
on the inside of the high-current fuse box cover.
Z15038
Z15792
FE_FG.book Page 10 Wednesday, January 14, 2009 7:08 PM
To Next Page
Loading...
Need help?
General
