6-12 Instruments and warning lamps
8 Engine control warning lamp
This lamp comes on when the starter key is turned
to “ON”. It should go out when the engine starts.
8.1 Illumination of warning lamp (red)
The red lamp illuminates when an abnormality is
detected in the engine control system or DPF sys-
tem. The engine output may be limited depending
on the location of the fault.
If the lamp illuminates, place the starter switch in
“ACC” or “LOCK” position for 3 minutes or longer
and then restart the engine. If the lamp stays off,
there is no problem. If the lamp illuminates again,
stop the engine and contact the nearest authorized
dealer.
The red lamp is also illuminated if you continue to
drive while the DPF indicator lamp quickly flashes.
Illumination of this lamp may indicate a blocked
DPF and/or faulty DPF system. If this lamp illumi-
nates during driving, stop the vehicle as soon as it is
safe to do so and perform the following inspection.
1. Hold the starter switch in the “ACC” or “LOCK”
position for more than 3 minutes, then restart
the engine.
2. If the warning lamp goes out, there is nothing
abnormal with the system.
3. If the warning lamp remains illuminated, have an
authorized dealer perform the necessary
inspection.
8.2 Illumination of warning lamp (amber)
The amber lamp illuminates if the exhaust gas con-
trol system has some abnormality and its function
deteriorates. If the lamp illuminates, place the
starter switch in “ACC” or “LOCK” position for 3 min-
utes or longer and then restart the engine. If the
lamp stays off, there is no problem. If the lamp illu-
minates again, have your vehicle inspected at an
authorized dealer in the earliest opportunity.
Z18589
Z11795
FE_FG.book Page 12 Wednesday, January 14, 2009 7:08 PM
To Next Page
Loading...
Need help?
General
