--.
-
,.
L
P
L-
P
L
A8
Inspection and Maintenance
P
c
I
-i
L
P
If data communications is not possible
The hardware settings or
cable
connections have probably not
been done correctly.
Use the troubleshooting charts in Sections 11.3.2, 11 3.3, and
11.3.4 to determine and correct
the
problem and then repeat the
loopback test.
After the loopback test is finished, a computer link which uses
the dedicated protocol
is
enabled.
When a computer link uses the
no-protocol/bidirectionai
mode,
do the following:
oset the mode switches.
.Turn the power to the PC CPU
OFF/ON
or reset the PCCPU.
After doing the above, the computer link operation is enabled.
The AJ71C24 module itself requires no particular inspection procedures.
However, carry out the inspections listed in the PC CPU User's Manual to
ensure optimum system performance.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
