Mitsubishi A Series - Page 176

8. COMMUNICATIONS USING DEDICATED PROTOCOLS
MELSEC-A
8.7.4 Batch mfte In unitr of btt8
(a) Using the BW command (ACPU common command)
Batch reed (bit) c
Computer
An1 c24
L
)erlgnatlon Method I
St. No. : Station number
Designation in protocol 1 is shown below.
mmd Character area A
Ddgnatkmddsvi
range to b read '/
POINT]
To designate the device range, the following conditions must be met:
0 1 I number of device points I 160
0 (Head device number) + [(number of device points) - 11s maximum
device number
To write data to 5 points from M903 to M907 in station "0".
(Message wait time is 0 msec)
Computer
An1 c24
Check sum is calculated within this range
*
,I ,,I 1 IIII I
E
Q
N OIFFBWO Y o o o 3 o 5 o 1 1 o 120
I 0. IJO*J*l4L,lbl42*,57"I Jo* I &,xn, 8" ,a. ,S" I x. I 35. 1% I 31w 11. I a. ,)I* l2"&
Designation to turn OFF M903 C OOFF
A
Designation to turn ON M904
K
dd a.,xI. *6.&
Designation to turn ON M905
Designation to turn OFF M906
Designation to turn ON M907
8-34
i
c
1-
b
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com