Mitsubishi A Series - 4. SETTINGS AND PROCEDURES BEFORE OPERATION; 4.1 Settings and Procedures before Operation

c
r-
n
c-
P-
-,
..
P
L
c
C.
P
c_
f-
1)
4. SElTINGS AND PROCEDURES BEFORE OPERATION
, ,. . , ..> %. ,, , . . I ,.
MELSEC-A
4. S€ITINGS AND PROCEDURES BEFORE OPERATION
4.1 Settings and Procedures before Operation
The settings and procedures which have to be done before
a system using the
AJ71C24 can be started are described below.
Determine the system configuration ...... Sea %&oil 23.
...... See section 4.32.
,.....See Won 4.3.1.
I..... sectbll 4.3.3.
......See Section 4.6.
External wiring ......Sea Sections 3.2, 4.5.
I
Loopback test ...... b -54.3, 8.15.
I
I
Initialize using a sequence program ......See Sbction 7.
I Aseq~~enosprogmmfordatatranmia
Create a data communications program
........ sion or switching the mode must use
the folkwing fundions:
0 Data transmission in the no-protocol/
bidirectional mode
A
Operation
e Data transmission using the on-
demand function of the dedicated
protocol
0 Signal input using the global function
0 Switching the mode
of the dedicated protocol
Appendix 12 contains the form sheet for recording the setting values of the AJ71C24.
4-1
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com