5 - 120
MELSEC-A
5 DATA USED FOR POSITIONING CONTROL
Setting item Setting details
Cd.27
Step mode
•
When using step operation, set which unit to step with.
Cd.28
Step start information
•
When using step operation, set whether to continue or restart operation.
Cd.29
Skip command
•
Set "1" to skip the current positioning.
Cd.30
New torque value
•
To change the " Md.45 Torque limit stored value", set the new estimated torque
limit stored value.
•
Set the value within the " Pr.18 Torque limit setting value" range.
Cd.31
Positioning starting point No.
•
Set the "start point No. (1 to 50)" for executing block start (positioning).
(If setting the value other than 1 to 50, process it as "1".)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...