Mitsubishi A1SD75P2-S3 - Page 241

6 - 20
MELSEC-A
6 SEQUENCE PROGRAM USED FOR POSITIONING CONTROL
*
*
*
No.24 Error reset program
*
*
*
No.25 Stop program
<Error code read>
<Error code read complete confirmation>
<Error reset command pulse>
<Error reset execution>
<Error code read complete OFF>
<Stop command pulse>
<Stop execution>
<Axis stop signal OFF due to axis stop>
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com