11 - 20
MELSEC-A
11 MANUAL CONTROL
Position control by manual pulse generator operation
The command output during manual pulse generator operation is as follows.
[No. of command pulses] = [No. of manual pulse generator input pulse]
[
Cd.23
Manual pulse generator 1 pulse input magnification]
[Command speed*] = [Manual pulse generator input frequency]
[
Cd.23
Manual pulse generator 1 pulse input magnification]
*: When the manual pulse generator input frequency changes, the new frequency will
apply after a maximum of 180ms delay.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...