12 - 49
MELSEC-A
12 CONTROL AUXILIARY FUNCTIONS
(3) Setting the torque change function start signal
To use the "torque change function", write the data shown in the following table
to the AD75 using the sequence program.
The set details are validated when written to the AD75.
Buffer memory address
Setting item
Setting
value
Setting details
Axis 1 Axis 2 Axis 3
Cd.30
New torque value
Set the new torque limit value. 1176 1226 1276
* Refer to section "5.7 List of control data" for details on the setting details.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...